# Adjusting stick-out in ArcWelding PowerPac  \[ArcWelding PowerPac\]

**URL:** <https://tech-community.robotics.abb.com/t/adjusting-stick-out-in-arcwelding-powerpac-arcwelding-powerpac/3937>\
**Category:** PowerPacs\
**Created:** [December 1, 2010, 1:52pm UTC](https://tech-community.robotics.abb.com/t/adjusting-stick-out-in-arcwelding-powerpac-arcwelding-powerpac/3937 "2010-12-01T13:52:45Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![TomR](https://avatars.discourse-cdn.com/v4/letter/t/d2c977/32.png) [@TomR](https://tech-community.robotics.abb.com/u/TomR)\
**Post date:** [December 1, 2010, 1:52pm UTC](https://tech-community.robotics.abb.com/t/adjusting-stick-out-in-arcwelding-powerpac-arcwelding-powerpac/3937/1 "2010-12-01T13:52:45Z")

</div>

If I change the stick-out for a particular path, does it change the programmed position or the tool tcp position, or something else?

---

<div class="post-metadata">

**Author:** ![TomR](https://avatars.discourse-cdn.com/v4/letter/t/d2c977/32.png) [@TomR](https://tech-community.robotics.abb.com/u/TomR)\
**Post date:** [January 31, 2011, 2:02pm UTC](https://tech-community.robotics.abb.com/t/adjusting-stick-out-in-arcwelding-powerpac-arcwelding-powerpac/3937/2 "2011-01-31T14:02:24Z")

</div>

Anyone?

---

<div class="post-metadata">

**Author:** ![KgaOfflineCenter](https://avatars.discourse-cdn.com/v4/letter/k/3bc359/32.png) [@KgaOfflineCenter](https://tech-community.robotics.abb.com/u/KgaOfflineCenter)\
**Post date:** [February 2, 2011, 11:53am UTC](https://tech-community.robotics.abb.com/t/adjusting-stick-out-in-arcwelding-powerpac-arcwelding-powerpac/3937/3 "2011-02-02T11:53:16Z")

</div>

Hello TomR,

It will change the target position.

BR / Henrik