Hi, I have just connected and configure my 2 conveyors drives linked by DeviceNet I/O bus.
Unit and signals (start, stop, speed, fault reset) are already created and tested OK.
What do i need to do more to get the drives under the CNV1 CNV2 Mechanical Unit control (i.e jog etc).
The only way to control the conveyors is by setting start and stop I/O signals.
To be able to jog an external motor you must use an ABB motor kit (MU-10,MU-20,MU-30), which allows you to coordinate the motion. The problem is that you can’t run the a linear external axis continuously.