# finger and operations missing in wizard

**URL:** <https://tech-community.robotics.abb.com/t/finger-and-operations-missing-in-wizard/11433>\
**Category:** Wizard Easy Programming\
**Created:** [May 12, 2024, 8:57pm UTC](https://tech-community.robotics.abb.com/t/finger-and-operations-missing-in-wizard/11433 "2024-05-12T20:57:41Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![leonardodo](https://avatars.discourse-cdn.com/v4/letter/l/48db29/32.png) [@leonardodo](https://tech-community.robotics.abb.com/u/leonardodo)\
**Post date:** [May 12, 2024, 8:57pm UTC](https://tech-community.robotics.abb.com/t/finger-and-operations-missing-in-wizard/11433/1 "2024-05-12T20:57:41Z")

</div>

In RobotStudio 2023 I create a new station with an IRB14050 robot then

- add a SmartGripper and link it to the robot

- add a Virtual Controller from Layout (robotware 7.10)

- Sync with RAPID

- open the Virtual Flexpendant

- launch the Wizard APP (1.5.1)  
All is fine but I’m missing the Operations button (upper right of the main window) and all the blocks related to the gripper. I get no finger blocks nor vacuum blocks.

What am I doing wrong? If I open a backup taken from an actual controller and robot I get all the missing blocks. Is there some configuration I skipped? Checking the controller configuration I can see it is configured for a SmartGripper. How can I get gripper related blocks?

---

<div class="post-metadata">

**Author:** ![leonardodo](https://avatars.discourse-cdn.com/v4/letter/l/48db29/32.png) [@leonardodo](https://tech-community.robotics.abb.com/u/leonardodo)\
**Post date:** [May 14, 2024, 10:29am UTC](https://tech-community.robotics.abb.com/t/finger-and-operations-missing-in-wizard/11433/2 "2024-05-14T10:29:24Z")

</div>

Problem solve thanks to the Wizard Support. The following controller options are needed: Collision detection, Multitasking.