# PLC Connection to IRC5

**URL:** <https://tech-community.robotics.abb.com/t/plc-connection-to-irc5/5134>\
**Category:** Robot Controller\
**Created:** [October 16, 2012, 10:30pm UTC](https://tech-community.robotics.abb.com/t/plc-connection-to-irc5/5134 "2012-10-16T22:30:51Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Nata\_lia](https://avatars.discourse-cdn.com/v4/letter/n/f19dbf/32.png) [@Nata\_lia](https://tech-community.robotics.abb.com/u/Nata_lia)\
**Post date:** [October 16, 2012, 10:30pm UTC](https://tech-community.robotics.abb.com/t/plc-connection-to-irc5/5134/1 "2012-10-16T22:30:51Z")

</div>

Hi, I have an IRC5 controller with following IO features  
888-1 PROFINET IO m/s  
Card type CP1616  
Internal Slave Cfg In  
Slot 1 : DI 64 byte module

Internal Slave Cfg Out  
Slot 2: DO 64 byte module

I connected the PLC in the Ethernet port of my PCI card to check the IO with the PLC.  
Do I have to set up IP address or something to be able to talk to PLC? or I need to give some information to the PLC?

I have defined all my Io signals and it works fine in the simulation mode. But all I need to do now is get it connected to real PLC
