PMPump4 failed to request new target set from proj [PickMaster 5]

PickMaster
1

Below is an error message on the FP that I get when trying to run a new project. I have checked all of the I/O values of the products and formats and have tried them all as different integers. System will not run.

Description

The target pump process “PMPump4” failed to request new target set from project.

Consequenses

Last trigged operation set can not be pushed into the Work Area queue.

Probable causes

The trigged operation set (-1) is not configured in the project.

The trigged combination of product I/O value (0) and format I/O value (0) is not configured in the project.

Status: 0

Actions

Review the project setup.

Check the product and format selection groups signal values.

2

Hi John,

As the error message shows, the read values on the GI’s are 0/0, and there is no operation set configured for those values for this workarea.

-Check the I/O values of the operation sets,
-Check the signal named of the workarea.

/Mats