# Programming tab  \[Bending PowerPac\]

**URL:** https://tech-community.robotics.abb.com/t/programming-tab-bending-powerpac/3985
**Category:** PowerPacs
**Created:** [January 2, 2011, 7:59pm UTC](https://tech-community.robotics.abb.com/t/programming-tab-bending-powerpac/3985 "2011-01-02T19:59:32Z")
**Posts on this page:** 2
**Page:** 1

<div class="post-metadata">

### Author: ![CorreiaRS](https://avatars.discourse-cdn.com/v4/letter/c/58956e/32.png) [@CorreiaRS](https://tech-community.robotics.abb.com/u/CorreiaRS)
#### Post date: [January 2, 2011, 7:59pm UTC](https://tech-community.robotics.abb.com/t/programming-tab-bending-powerpac/3985/1 "2011-01-02T19:59:32Z")

</div>

hello guys,

I’m just trying to do a programming on Bendong PowerPac, but something is missing to me.

I’ve defined layout and all tools, bendings, etc, but when I go to “programming” ribbon-rab, most of instructions are bloqued.

I can’t find why.

any clue about this?

thank you 🙂

---

<div class="post-metadata">

### Author: ![CorreiaRS](https://avatars.discourse-cdn.com/v4/letter/c/58956e/32.png) [@CorreiaRS](https://tech-community.robotics.abb.com/u/CorreiaRS)
#### Post date: [January 9, 2011, 6:38pm UTC](https://tech-community.robotics.abb.com/t/programming-tab-bending-powerpac/3985/2 "2011-01-09T18:38:11Z")

</div>

well, after a couple of hours testing solutions with a teacher from FEUP (Portugal), I believe we understood the problem 🙂  
I’m just trying everything from blank now to validade it 😉

if all goes well, I will post here the solution for this problem 😉

regards,