So have you resolved the problem?
Yes i believe so. Knock on wood it has been running great, for now. I haven’t changed that PulseDO yet, I need to look at the PLC first to make sure it doesn’t need to be changed in there also.
Ok, but can I ask what did you change and what was the issue?
Or, for now you didn’t had this problem anymore?
Feedback for us is also important as for you is the answer for your question.
I just changed the Program. I used an older copy of the same Program. Once I did that It has never done it again. Could that PRG, or file have been corrupted for some reason? I pulled it off a flash drive, and it hadn’t been used for a while. I didn’t have the PRG on the ram because I had to do a cold start on it due to the (rlsup.c 2910) error.
Or could the contacts stick in the PLC modules, I understand that they either are good or bad, but I have seen relays contacts stick randomly. And with the PulseDo command being a short burst, it is not be enough time to release the contact?
We have been running it for a while now and no problems with it. My concern was Keeping it from doing it again, one for safety and to keep from breaking it.