Synchronise to StationProcedures Not Showing Up

RobotStudio
1

I have some procedures that just don’t seem to show up in the synchronise to station list.

Any ideas why, I can run the program in robotstudio and it works fine, but the targets used in these procedures just arent visble anywhere in robotstudio. I have four procedures TouchProcA, TouchProc2A, TouchProcB, TouchProc2B, that are all very similiar just with a different robtarget (initial position) and search direction. And I cannot get these to show up in the list to synchronise.

2

Hi

I have the same effect if I use procedures with parameters.

Best regards

Marcel

3

yes that’s it, all of my procedure with parameters don’t appear.

Is this a known feature/bug?

4

Hi All,

This is a known feature/limitation in RobotStudio.
We have it on our list for improvements for future releases.