# variable Weavewidth in weavedata between 2 targets

**URL:** https://tech-community.robotics.abb.com/t/variable-weavewidth-in-weavedata-between-2-targets/11356
**Category:** RAPID Programming
**Tags:** arc-welding, weavedata
**Created:** [February 16, 2024, 10:48am UTC](https://tech-community.robotics.abb.com/t/variable-weavewidth-in-weavedata-between-2-targets/11356 "2024-02-16T10:48:13Z")
**Posts on this page:** 2
**Page:** 1

<div class="post-metadata">

### Author: ![Daper](https://avatars.discourse-cdn.com/v4/letter/d/8491ac/32.png) [@Daper](https://tech-community.robotics.abb.com/u/Daper)
#### Post date: [February 16, 2024, 10:48am UTC](https://tech-community.robotics.abb.com/t/variable-weavewidth-in-weavedata-between-2-targets/11356/1 "2024-02-16T10:48:13Z")

</div>

Hello all,

Is there any way to increase the weave width between 2 targets using the ArcL instruction ?  
For instance, start movement without weaving and at first target and reach the next one with a10 mm wide weaving ?

---

<div class="post-metadata">

### Author: ![Daper](https://avatars.discourse-cdn.com/v4/letter/d/8491ac/32.png) [@Daper](https://tech-community.robotics.abb.com/u/Daper)
#### Post date: [February 21, 2024, 10:08am UTC](https://tech-community.robotics.abb.com/t/variable-weavewidth-in-weavedata-between-2-targets/11356/2 "2024-02-21T10:08:45Z")

</div>

For those who may have the same question, It can be done using the ArcRefresh command within a timed interrupt