# Virtual Controller wont cold boot....

**URL:** <https://tech-community.robotics.abb.com/t/virtual-controller-won-t-cold-boot/623>\
**Category:** RobotStudio S4\
**Created:** [February 10, 2006, 12:22pm UTC](https://tech-community.robotics.abb.com/t/virtual-controller-won-t-cold-boot/623 "2006-02-10T12:22:49Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Neily03](https://avatars.discourse-cdn.com/v4/letter/n/c6cbf5/32.png) [@Neily03](https://tech-community.robotics.abb.com/u/Neily03)\
**Post date:** [February 10, 2006, 12:22pm UTC](https://tech-community.robotics.abb.com/t/virtual-controller-won-t-cold-boot/623/1 "2006-02-10T12:22:49Z")

</div>

If i create a new VC using the key ID for a robot and then set this new VC for my robot when i start VC it just sits there saying “starting Virtual Controller, please wait” ?? It doesn’t go any further…

☹

---

<div class="post-metadata">

**Author:** ![Anders\_S](https://avatars.discourse-cdn.com/v4/letter/a/ce7236/32.png) [@Anders\_S](https://tech-community.robotics.abb.com/u/Anders_S)\
**Post date:** [February 15, 2006, 12:58pm UTC](https://tech-community.robotics.abb.com/t/virtual-controller-won-t-cold-boot/623/2 "2006-02-15T12:58:53Z")

</div>

Do you have any AntiSpyware program running on your PC ?  
If the answer is yes, disable that program and try again.

If the answer is no, is it more difficult to say what the problem is, but if you e-mail the key ID to me can I take a look at it.  
E-mail address: [anders.spaak@se.abb.com](mailto:anders.spaak@se.abb.com)
