Hello,
Is there more information somewhere about setting up the smart components for the new spray visualization?
Yes a tutorial would be good on this.
Neily have you tried anything yet? I cant find that first system node that defines the A1brush…
Got it.
-
Create your smart component.
-
Add the three components
-
create an i/o signal for that smart component. this will receive the signal from the controller
-
add connections between components (I used the design tab)
-
Then the key is to go into simulation tab > station logic > design tab > select the drop down from your controller > select A1brush > then make a connection between that unit, and your new spray simulator
Now your controller GO for A1brush will trigger your newly created smart component…
the next thing I am trying to figure out is how to simulate with multiple parts.
The PaintApplicator component will only accept 1 part.
I guess you could either
- Use one Applicator component for each part,
- Update the Part property as the robot moves to a new part, or
- Merge the parts into a single part.
I tried 1, it produced some funky results.
I think 2 would be the best route in my case, but I haven’t figured it out yet.
3 is difficult in my situation unfortunately.
So after a bit trial and error we’ve got this working:
Bonjour à vous
merci pour tes explications C63amg vraiment bien ton post,par contre j ai bien fait toutes les étapes que tu décris mais quand je lance ma simulation ça ne peint pas les pièces , pourrais tu m aider??
Neily03 j ai vu ta vidéo sur YouTube tube j aimerais vraiment arrivé à ce résultat c vraiment bien …
j espère que vous pourrais m aider.
d avance merci,
There is a bug with using multiple applicators that will be addressed in 6.07. (They would unintentionally share the same texture.)
Johannes