Analog output signal

Robot Controller
1

Hello,

I have tried to set a analog output signal but is not working as intended. When I set value to eg. 5.00, change to 4.587481.

I have attached properties of the signal.

image.png
image.png550×650 33.9 KB

Hope someone can help. :slight_smile:

Thanks in advance.

Best regards,

Michael Petersen

image.png
image.png550×650 33.9 KB

2

I solved the problem. The Maximum Bit Value was wrong. I changed both Maximum Logical and Maximum Bit Value to 32000 and it works as intended.

3

Hello @michael.petersen I have a question related to the setting you did above, Could you please tell me these numbers max and min indicates what exactly because I am so confused adjusting them of AO.
Thanks in advace