Auto mode error when starting arcpack [ArcWelding PowerPac]

RobotStudio PowerPacs
1

Hello, when i start arcpack from the process menu i have been getting an error popping up:

“: Not able to set the controller in auto mode retry operation”

IN the output window i am getting " ForceControllerToAutoMode Failed: The NetScanID is no longer in use. Controller removed from list. 26/04/2007 11:09:50 AM"

Does this make any sense to anyone?

2

I restarted the computer and it seemed to of fixed things.

The old restart the computer trick!

3

Hi Cole

I get this message often if i am using the flecpendan.

When i set the flexpendant in automode and the start Arcweldpowerpack this message appears.

i then save the station and restart the station again.