Hello,
With a Virtual Controller made from backup, in its ‘Paths & Procedures’, I cannot edit LowPoint and HighPoint for WZBoxDef intruction, only have combo list with pos variables.
With a fresh install VC, it is possible, maybe because there is no pos variables declared.
Even if I synchronize from RAPID with direct value, it is showed correctly but cannot edit it.
In same time I don’t see it in 3D view. PS:You have to be sure each values (x,y and z) in LowPoint are lower than in HighPoint.
After I-Start VC, I can edit points values but still don’t see it in 3D view.