Create module using Webservice?

Developer Tools
,
1

Hello, How Can I create a new module using WebService?. I found how to load, unload, delete, etc.
Thanks

2

Hi Jorge,

I’m not sure about WebService, I have never used it,
but the standard Write instructions can be used in RAPID, e.g:

VAR iodev iod_Dev;

Open "HOME:", \File:="asdtest.mod", iod_Dev, \Write;
		
! Write Doc Header
WriteString iod_Dev, ByteToStr(37, \Char) + ByteToStr(37, \Char) + ByteToStr(37, \Char) + ByteToStr(0x0A, \char)
+ ByteToStr(0x09, \Char) + "Version:1.0" + ByteToStr(0x0A, \char)
+ ByteToStr(0x09, \Char) + "Language:ENGLISH" + ByteToStr(0x0A, \char)
+ ByteToStr(37, \Char) + ByteToStr(37, \Char) + ByteToStr(37, \Char);
		
! Write Module Title
WriteString iod_Dev, ByteToStr(0x0A, \char) + ByteToStr(0x0D, \char) + ByteToStr(0x0A, \char)
+ "MODULE asdtest" + ByteToStr(0x0A, \char)
+ "ENDMODULE";
		
Close iod_Dev;

If the file does not exist, the Open instruction creates it. In this case it writes a blank module afterwards.
Special characters need to be added using ByteToStr. It’s not the most eloquent solution, but is there a way you can make a RAPID procedure call using webservice?

I hope this helps,
Regards,

Harry

3

These days your modules don’t need that header, btw.

4

I’m curious, why is that? Or why did they ever need the header? I’d seen it in examples so I’ve been using it.