hi i am new to programming robots and robot studio. i have been playing around with the software and so far i am able to create a path i want the robot to follow and simulate it in offline mode. at the moment i am not connected to my robot through a network. i am wondering if there is a way i can save a program file on a USB drive and plug that into the flexipendant and load the program into the program editor??
Hi,
If you right click you get the dialogue box that allows you to save the program (as shown).
Or if you only want to save a module right click on the module and you get a similar dialogue box allowing you to save the module.
You can then open it via the FlexPendant on the real robot.
Regards
Graeme
haha well that was easy thanks very much