Hello, how I set I/O signal in RobotStudio verzion higher than 6 ? There is missing Unit so what I should do ? Thanks.
Nobody ? 
Hi,
You no longer need a virtual unit to create virtual I/O signals - so just create the signal in the EIO file without reference to a unit or a physical address (just name and type of signal).
Regards
Graeme
Hi there
How to make I/O accessible for smart components?
Take a look at this https://youtu.be/gH7_pLTOO2U
Hi!
I have the same question. I design a smart component for a 2 parallel fingers gripper and I want that the robot controls the gripper, but I don’t know how do it.
Please help me.
Where is the EOI file?
Thanks!!!
Hi!
I create the Gripper and the I/O signals with a smart component. I you need to setup I/O connections between the gripper and the robot system, but I don’t find the I/O of the robot. How could I do this?
I read something about EOI file, what is this?
Thanks!!!
There are some videos about smart components in this thread
This one is about smartcomponets and how to connect controller IOs to SC IOs
/Pavel