SafeMove final steps (I think?)

Robot Controller IRC5
1

I am trying to implement very basic Virtual SafeMove cell. And I think I am at the final goal of validating the config and locking it.

But I need to get past a few issues.

On station load and controller startup I get the following errors.

image.png
image.png1245×849 70 KB

I have not yet validated and locked config, so I assume it goes immediately into superior stop state 1.

Then warns Automatic Mode Warning 90526

image.png
image.png580×145 7.31 KB

So I switch it into manual mode and turn on motors, then try to address next error
CBC cyclical brake check

image.png
image.png1920×1080 560 KB

Execute

image.png
image.png1920×1080 560 KB

Then Error
37231 Brake Performance error for all 6 axis. What the heck am I missing?

image.png
image.png1920×1080 654 KB

Controller options

image.png
image.png1009×493 13 KB

Stop Config
image.png
image.png776×666 44.6 KB

Safe IO CIP input Signals

image.png
image.png1059×391 18.6 KB

Safe IO CIP Output Signals

image.png
image.png1111×580 43.7 KB

SafeMove Settings CBC

image.png
image.png1064×939 110 KB

Controller setting Safe Zone Tool Position
image.png
image.png1076×979 114 KB

2

Did you find a solution?

3

Did you already find a solution? I have the same problem.

4

Hello. Regarding the “Brake performance error” when using a virtual system. This is an bug in RW. It has been corrected in RW6.12. Solution is to upgrade RW or to simply disable CBC while running the virtual system.

BR//Mats

5

SafeMove in a virtual controller can cause problems. One is CBC, I only activate it in the real robot. The other problem I often have is when using ”view robot at target”. SafeMove doesn’t seem to like when robot is snapped between positions. Warm start is sometimes needed to get rid of the safety controller errors.