Hi there,
i had to setup my PC completely new due to some deleted things…
Now i have instlled RAB 5.12, RS 5.12 and RW 5.12.
Finally i installed the recompiled Screenmaker 5.12. Whn i then start RS 5.12 with a controller active, and try o start ScreenMaker, the attached error message comes up.
Who can give me a help on this???
This is an urgent item, as i wanted to show the Screenmaker next week in an internal produt presentation to make the guys promoters of Screenmaker…
Regards
Thomas
Hi Thomas,
This erros comes when there is a mismatch in the version. We will try to fix these errors.
In the meantime, where did you get ScreenMaker 5.12?
Thanks
Hi Thomas
which build of Screen Maker 5.12 are you using ? if it is the latest Screen Maker 5.12 executable (ScreenMaker.5.12.3076.0138), then please try to remove your RAB 5.12 from your laptop /PC and then load the above Screen maker build. you may get a solution …
Try a released build of RS5.12 ( Avoid any RS 5.12 Revision build)
Let’s know if you could get a solution.
Regards
Hi,
during the test of the RW 5.12 release candidate here in germany we got contact with Steve via Jonas Stigeberg and he gave us the version 0135.
This i have used even with an installed RAB 5.12 RC without problems, therefore i reused it with the final RS version and the final RAB version installed as well, resulting in the posted error…
Regards
Thomas
PS.: By the way, we (you or who else at ABB) should post the latest verson always at the download page in the developer section…
There is a ScreenMaker 5.12 CTP “recompile” now available for download on the Downloads site.
Steve