Hello all,
I have a robot within a cell in RobotStudio, and I’m trying to generate a path.
I have created a series of targets, which are well within the robot’s reach. However, when I right-click on them and select ‘Jump to Target’ or ‘View Robot At Target’, I get a message stating that the target is either out of reach, or no valid configurations were found. I know the target is within reach, because I can manually jog the robot’s axes and place it there.
Until now, I’ve been getting around this issue by using joint targets, but this is a very time-consuming process and I’d appreciate if anyone had any insight as to how to get this working!
Best regards, Peter.