I’ve tried to restore the controller from a previous backup(s) every time I get error 80001 “Stationname must match if interfaces are the same”
what is this?
Is that a real controller or a virtual controller in RS?
real controller
In that case I would check to see if the controller has run out of storage space, if possible.
I’m not sure storage space has got much to do with “Stationname must match if interfaces are the same” but there is loads of it
Yeah, I was overlooking that. What could station name mean? Do you have external axes in this setup?
wish I new, it’s just a robot with a built in io module and a profinet connection to a plc. It’s a bit of a fundamental flaw if you cant restore the backup that was made the day before!
Search the backup for Stationname.
I have the same problem, when trying to send IO changes to the robot from ioEngineering. i get the error: 80001: Stationname must match if interfaces are the same
I cant find station name anywhere
so i think the station name gets assigned to the robot by the profinet plc. In the end we gave up trying to used profinet safety signals and hard wired it.
Hello,
It happened to me too. I solved it by changing the Profinet station name in IO configurator to something random. Then restarted and asked the PLC programmer to assign the station again. After it worked without problem.
Alternatively, you can open the EIO.cfg file inside the backup and delete the station name assigned by the PLC during naming in the # PROFINET_NETWORK section. Then save the EIO.cfg file within the backup. Afterwards, the backup can be restored using RESTORE.
Interesting ideas, but the machine has been at the customer site for the last year!
The last couple of machine have been ethernetIP so I’ve not come across the problem again.