Where I get the kxt files for IRB4600 simualtion

RobotStudio
1

Dear sir,

I download the IRB4600 rslib files in library,but no kxt files attached, so I can not do the simulations, where can I get the kxt files to continue the simulation.

Best Regards!

Steven Xu

2

Hi Steven,

Here you go: IRB4600_kxt.zip

regards,
Johannes

3

Hi Johannes,

Very thanks for your help!

BR/Steven

4

Dear sir,

I have a IRB5400-02 robinstall files in library,but no kxt files attached, so I can not make a system file and startup file for robot, where can I get the kxt files to continue the making It .

Best Regards!

5

You can create systems for all supported robot models using the System Builder and use them for offline programming in RobotStudio. To download a system to a physical controller you need a real system key. Normally, this comes with your robot installation.

However, I am not familiar with the version IRB5400-02 and to my knowledge it is not supported by RobotWare. To my knowledge, the IRB 5400 series comes the following versions:

  • IRB 5400-12, Slim arm
  • IRB 5400-13, Slim arm on Clean-wall rail
  • IRB 5400-14, Slim arm on In-booth rail
  • IRB 5400-22, Process robot
  • IRB 5400-23, Process robot on Clean-wall rail
  • IRB 5400-24, Process robot on In-booth rail
6

hi Dear Henrik
I have robinstall program and i making system and program for Robot ABB, but iwhen i attach keystring in robinstall for making PA servis, not support my key.
Do you have key for this problem ?

a.abaee

7

RobInstall is used to create systems for S4 robots and the System Builder in RobotStudio is used for IRC5 robots. Do you have an S4 robot or an IRC5 robot?

8

S4 Robot

9

my screenshot