Programming tab [Bending PowerPac]

RobotStudio PowerPacs
1

hello guys,

I’m just trying to do a programming on Bendong PowerPac, but something is missing to me.

I’ve defined layout and all tools, bendings, etc, but when I go to “programming” ribbon-rab, most of instructions are bloqued.

I can’t find why.

any clue about this?

thank you :slight_smile:

2

well, after a couple of hours testing solutions with a teacher from FEUP (Portugal), I believe we understood the problem :slight_smile:
I’m just trying everything from blank now to validade it :wink:

if all goes well, I will post here the solution for this problem :wink:

regards,