I was told that it is possible to reverse the weld direction for a MultiPass weld and/or a weld programmed in RobotStudio…
(i.e.: 1st weld goes from L-R, the 2nd I want to go from R-L, and 3rd L-R, so on and so forth…)
Is this true?
If yes, how do I do it???
Hello,
Earlier ABB used AWC with multipass and now MultiPass in Weldguide. You can run the same code in the virtual controller.
BR / Henrik
In your multidata you define the direction you require.
I am sorry for the ignorance…
But, Istill am not sure on how to reverse the direction of a “Multipass” weld using the “ArcStoreOn/Off” feature…
I know that I can just teach the different directions, but is it possible to do this via ArcStoreOn/Off of in RobotStudio?
Thank you for your patience…
Dory England
Ridewell Corp.
Springfield, MO, USA
webwiz/2637/Multipass_Example.zip
Hi
You can do it using the ArcRepl Instruction defining the direction in the multidata. PLease find attached a zip file that may explain it. If not let me know and I’ll try to explain better. There is also a weldguide manual that ABB produce that may help.
Outstanding!!!
I have overlooked this time and time again…
I will try what you sent me…
No news will be good news…
I appreciate your help…
Thanks again,
Dory England
Ridewell Corp.
Springfield, MO, USA