To create a tool that can grip and release, I must create a mechanism and then convert it to tool?

RobotStudio
1

I’ve created a simple tool in Solid works and I want to convert theses geometry in to tool, but I’d like this tool could be simulated with two possition : opened and closed. How I can do this??

Thanks very much.

Rafael

2

I think your tool is only one piece. Tool should be do with 3 pieces. I send you my gripper when I be at computer.

3

I build my efektor with these steps so I hope you made it.

1.PNG.jpg
1.PNG.jpg558×621 94.3 KB

2.PNG.jpg
2.PNG.jpg472×681 75.2 KB

3.PNG.jpg
3.PNG.jpg474×579 95.5 KB

4.PNG.jpg
4.PNG.jpg501×686 86.3 KB

5.PNG.jpg
5.PNG.jpg497×638 89.7 KB

4

Thank you St4rk!

I could not understand everything because it is in Slovak. I’ll try to translate gradually.

One last question

Regards!!

Rafael

5

Sorry but I am from Slovakia, but if you will have some problems, write a message.