Conveyor tracking setup errors

RobotStudio
1

Hi,

I get two errors when trying to set up a conveyor tracking station in RS 5.12.
1st: When going in to ‘Home/RobotSystem/Conveyor tracking/Setup’ I directly get an error that says ‘No useful workobjects could be identified. The setup cannot be completed successfully!’.
2nd: No mechanical unit (Conv1) could be found in ‘Offline/Encoder Unit’.

What do I do wrong?

Best regards M Johnson

2

Hi,

you need at least one workobject with the below settings:
Move by Mechunit : your conveyor
Programmed : False

3